NCOP I-SH Straight Drop Level I Duty Holster Ballistic Nylon

PRODUCT NAME: NCOP I-SH STRAIGHT DROP LEVEL I DUTY HOLSTER BALLISTIC NYLON

To fit a 2 1/4" duty belt.

** For GSA and Volume Discounts please email esales@rptactical.com **

HARDWARE

1. Snap - Durable dot snap, solid brass, black coated

2. One "T" nut plate assembly

3. Four 8-32 x 5/8 oval head long lock

4. Metal Plate - 6213 Shank

5. Sight Channel - advanced Polymer

6. One clock spring 3/4" x 4 1/4"

7. One "T" nut belt tension receptacle

8. Three BT-42 black screw post dime slot

9. One 8-32 x 1/2" black truss head screw long lock

10. One reinforced rubber tubing

11. High Density Polyethylene

12. Three #8 black counter sunk washer

GENERAL DESIGN AND CONSTRUCTION

The holster is constructed of a non-woven fabric with thermal transfer capabilities sandwhiched between Ballistic weave nylon front and back.

The features of the Cop I-SH are as follows: jacket slot, metal reinforced belt loop with belt locking device, straight drop, covered trigger guard, open bottom, sight channel and a reinforcement at the mouth opening for easy reholstering. Body tension screw adjustment for weapon retention.

The holster shall be constructed with two major parts: the reinforced belt loop and the holster body.

The belt loop will be made to fit snug on a 2 1/4" belt and the width of the loop will be 3 1/8" at the top part and taper down to 1" at the bottom. This loop must have a belt locking system.

A 4/5oz. leather patch will be sewn in place at the belt opening to cover the metal plate.

The body configuration will be such that after completion, it will form a thumb break with safety strap over the hammer of the weapon and permit the trigger guard to be covered.

Before assembling the front and the liner, a clock spring will be placed between the parts at the thumb break tab; also, the "T" nut plate assembly will be placed between the layers to later secure the belt loop. There will also be a sight channel installed.

After assembly, the holster will be heat form molded to be rigid for a long lasting good appearance. There will be three post and screw installed in the holster body at stress point to add lasting durability. All edges shall have a nylon binding sewn in place using B69 bonded nylon thread to prevent fraying and give a finished look to the product.

In the final stage of completion reinforcement screws are installed at stress points, top and bottom of the welted area.