NT Force Level 2 Plus Straight Drop Duty Holster Ballistic Nylon Twist & Up

PRODUCT NAME: NT FORCE LEVEL 2 PLUS STRAIGHT DROP DUTY HOLSTER BALLISTIC NYLON TWIST & UP

** For GSA and Volume Discounts please email esales@rptactical.com **

HARDWARE

1. Snap - Durable dot snap, solid brass, black coated

2. One "T" nut plate assembly

3. Metal Plate -

4. Sight Channel - advanced Polymer

5. One clock spring 3/4" x 4 1/4"

6. Three screws, oval head slot, black coated, 8-32 x 5/8" long lock

7. One "T" nut belt tension receptacle

8. One BT-42 black screw post dime slot

9. One 8-32 x 1/2" black truss head screw long lock

10. One reinforced rubber tubing

11. Acrylic thermoplastic trigger guard release

12. Polymer trigger guard hook

GENERAL DESIGN AND CONSTRUCTION

The holster is constructed of a non-woven fabric with thermal transfer capabilities sandwhiched between Ballistic weave nylon front and back.

The features of the NT Force are as follows: jacket slot, metal reinforced belt loop with belt locking screw, straight drop, covered trigger guard, open bottom and sight channel. Over the hammer safety strap, low profile thumb break, internal trigger guard hook, twist and lift.

The holster shall be constructed with five major parts: the reinforced belt loop, the holster body, the trigger guard hook, the trigger guard release and the Kydex reinforcement under the belt shank.

The belt loop will be made to fit snug on a 2 1/4" belt and the width of the loop will be 3 1/8" at the top part and taper down to 1" at the bottom. This loop must have a belt locking system.

A 4/5oz. leather patch will be sewn in place at the belt opening to cover the metal plate.

The body configuration will be such that after completion, it will form a low profile thumb break and a over the hammer safety strap and must cover the trigger.

Before assembling the front and the liner, a clock spring will be placed between the parts at the thumb break tab; also, the "T" nut plate assembly will be placed between the layers to later secure the belt loop. There will also be a sight channel installed. The trigger guard hook is installed, the trigger guard release and the heavy welt is put in place and secured by the post and screws.

After assembly, the holster will be heat form molded to be rigid for a long lasting good appearance. All edges shall have a nylon binding sewn in place using B69 bonded nylon thread to prevent fraying and give a finished look to the product.

To draw the gun, obtain a shooters grip, activate the low profile thumb break, slightly twist grip of gun inward toward your body and lift up.