NTOP Security SH Level 2 Top Draw Ballistic Nylon 1000 Denier

PRODUCT NAME: NTOP SECURITY SH LEVEL 2 TOP DRAW BALLISTIC NYLON 1000 DENIER

Slight cant muzzle to the rear to fit a 2 1/4" duty belt, this holster is designed for long lasting performance.

** For GSA and Volume Discounts please email esales@rptactical.com **

HARDWARE

1. Snap - Durable dot snap, solid brass, black coated

2. One "T" nut plate assembly

3. Three special low head, long lock screws T 15

4. Metal Plate - Steel ribbed shank metal

5. n/a

6. One clock spring 3/4" x 4 1/4"

7. One screw, oval head slot, solid brass, black coated, 8-32 x 5/8" long lock

8. One "T" nut belt tension receptacle

9. One BT-42 black screw post dime slot

10. One 8-32 x 1/2" black truss head screw long lock

11. n/a

12. One retention trigger guard locking device

GENERAL DESIGN AND CONSTRUCTION

The holster is constructed of a non-woven fabric with thermal transfer capabilities sandwhiched between Ballistic weave nylon front and back.

The features are as follows: jacket slot, metal reinforced belt loop with belt locking screw, straight drop, covered trigger guard, open bottom and the retention trigger guard lock system.

The holster shall be constructed with three major parts: the reinforced belt loop, the holster body and the special trigger guard lock system.

The belt loop will be made to fit snug on a 2 1/4" belt and the width of the loop will be 3 1/8" at the top part and taper down to 1" at the bottom. This loop must have a belt locking system.

A 4/5oz. leather patch will be sewn in place at the belt opening to cover the metal plate.

The body configuration will be such that after completion, it will form a thumb break over the hammer of the weapon and permit the trigger guard to be covered.

Before assembling the front and the liner, a clock spring will be placed between the parts at the thumb break tab; also, the "T" nut plate assembly will be placed between the layers to later secure the belt loop. There will also be a sight channel installed.

After assembly, the holster will be heat form molded to be rigid for a long lasting good appearance. All edges shall have a nylon binding sewn in place using B69 bonded nylon thread to prevent fraying and give a finished look to the product.

DRAWING INSTRUCTIONS

To activate simply release the low profile thumb break and continue moving thumb downward to release the secondary trigger guard release. At this time you will have a shooters grip, simply life the gun straight up. To re-holster, insert gun and push down to be sure the trigger guard lock is in place. At this time the gun is secure, for extra security always secure the thumb break safety strap.